V1 Engineering Forum

MPCNC setup from a Macbook to V1Pi

Mostly Printed CNC - MPCNC Advice

jeffeb3 (Jeffeb3) November 27, 2019, 9:33pm 6

Estlcam under Linux? Advice

I have it working under wine (playonlinux, actually) and it works fine. The fonts don’t work right, and the file browser is a windows file browser, but other than that, I have no complaints. I also have it installed in a VM, in case I need to do fonts, but honestly, it’s easier to use inkscape to do writing anyway. I roughly followed this, IIRC: http://www.cnczone.com/forums/uncategorised-cam-discussion/246464-running-estlcam-linux-using-wine.html Specifically, there was a useful post with th…

I will have to check. I think it is 32bit.

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled