I need to run a job with it and see what it does. This was just framing. It may act differently idk. Trying to get my air compressor moisture drain automation done then ill test it out and report back.
this is better than “oh 
I forgot to plug the laser in” or listening to the loud ass fan run all the time LOL
Here is the manual for the laser…
1 Like
Converting my Primo from mill to laser and had the same question. Being something of a neophyte with this I decided to just insert a G4 P5000 (pause in in thousands of a second) gcode to pause for 5 seconds to allow me to turn on the power to the laser. Unfortunately with this ‘solution’ I still need to be there when it finishes…
I just turn the laser power supply on with the jackpot power supply. I never could get the timing right and it was just easier this way.