Ideed it does, at the location below:
https://docs.v1e.com/electronics/jackpot/
Quick note, gpio.26 can have a quick pulse when starting. If you are using a 5V pin for your laser pin 27 is the better option for your enable pin.
but I’m not sure the language is correct. Note that it says enable pin. I think that should say output pin.
Lots of people are running only with a PWM output, not the enable (power wired directly to the laser module). I had laser module power wired directly to the JL1 laser for a while after finding out the VMOTs are low side switched.
I’ve never seen my laser glitch on jackpot power up , but then again from my JL1 thread the config ended up using GPIO27 for the PWM (Output pin).