How much can the filiment used in printing lowrider parts effect the rigidity?

[scrounge79 (Marion J. Makarewicz)]

Welcome @Setlab!

From the V1 site accordin to Ryan:

"I prefer PLA but PETG can be used, 3 walls, 30-55% infill. "

PETG isn’t as rigid, but it has its own qualities that lend itself to the effort.

Alternate filaments to use?

I printed most of my parts in PETG and a few in PLA/ABS. Here is my experience with all 3 ABS: works great at first but I saw layer separation over time. This might not have happened if I printed hotter and/or acetone bathed the parts. you also have to scale it up a little bit but be careful here since not all scaling up happens in the same way. PLA works good for parts that need to be rigid but not clamped down. Not good for parts like the pineapple couple or corners which need to be clamped…