Hi ,iwas trying to reprint a part i broke of lrv3
Last moth i added a bltouch to my printer
And today i printed a calibration cube before printing the part
And this came out jajajja any ideas
And this came out jajajja any ideas
1 Like
Looks like major overextrusion. Only time I’ve seen a cube come out like that it was 2x overextruding…
I would start at the beginning and do the 100mm extrusion test for E step calibration.
Might as well run through them all…
2 Likes
Ok txs,i was planning to upgrade to directdrive do i do that first ?
If you change the extruder and hot end, you will have to do a full calibration all over again
Thx for your for yor help
1 Like