Morning, everyone ! guys need your help, where can I get the firmware for MPCNC ? ready already ??? and how to connect 5 engines please tell me. I have already reviewed the entire site, but did not understand anything, I have RAMPS 1.4 and have CNC Shield, sorry for my bad English I’m from Russia and translate through a translator.
Is it ready for 5 engines?
Last question, and the circuit connection of the motors is what ?that is what motor where ? I mean backup.
Just plug them all in without the belts attached. Connect a computer or use the LCD to move each axis one at a time. Watch to see which motors move. Unplug all the power and USB before unplugging motors.
If any motor is spinning the wrong direction Then turn the motor wires around. That will make the motor spin the other direction.
Not found MPCNC_Ramps_T8_16T_LCD_32step_DualEndstop
Gays how to connect 5 motor? Ramps - MKS Base v1.5 Help please