Getting ready to wire to my Rambo Mini board which I bought from the V1 Store. I’ve read a lot of posts this morning, most of them over a year old. So I’m wondering if I hook my 12v control wires to pin 45 and the ground, does the current firmware support the laser or do I have to flash it? Do I nee…

Endurance Laser

mcsterls (Mike Sterling) February 20, 2021, 3:38pm 7

My laser uses the 12v ttl, so I think I can plug right into the Fan port and not have to tweak the firmware like here:

Is that correct?