Where does everyone get their bits from? I’m specifically curious about longer bits. Since I’m just starting out, I bought a cheap set of bits off Amazon. They have been fine so far. I also got a set of v bits from amazon. The problem with both sets (really the v bits) is how short they are. I was barely able to clear the bottom on the plate that holds the router with these bits. I would like to get some pretty long bits to be able to get through some maybe 1.5-2 inch stock. Is this asking too much of the lowrider and just bits in general? Either way, what are the typical material cut through limits and how long of a bit can I get?