Jonathjon
October 14, 2024, 1:55pm
38
Here is the one and only time I have ever stalled my spindle. Was with an 1 1/4” surfacing bit that needed the cutters flipped bad and was cutting deeper than the bit is height wise.
Helping a good friend of mine build a kitchen island and a work table for his wife. Had to build them narrow enough to fit through his door lol. He is going to pick up a countertop for the island but wr decided to build a countertop for the work table out of pine 2x4s. The glue up didn’t go as well as planned. Too many things going on at once lol. Anyways now we are on to flattening it and man did my surface bit take some deep cuts.
[IMG_5571]
[IMG_5573]
[IMG_5574]
[IMG_5575]
[IMG_5576]
[…